It automatically sets the label length. Depending on the size of the label, the printer feeds one or more blank labels.

It is used to copy an object or group of objects from one storage device to another. It is similar to the copy function used in PCs.

It cuts the label when the printer is in the Delayed Cutter PRINT MODE.

It deletes objects, graphics, fonts, and stored formats from printer's storage areas. Objects can be deleted selectively or in groups.

It sends the specified commands to the printer.

It stops printing after the current label is complete (if one is printing) and places the printer in Pause Mode.

It prints the printer configuration label. The printer configuration label contains information about the printer setup, such as sensor type, network ID, ZPL mode, firmware version, and descriptive data on the R:, E:, B:, and A: devices.

It prints a label listing barcodes, objects stored in DRAM, or fonts.

It resets all of the printer's internal software, performs a power-on self-test (POST), clears the buffer and DRAM, and resets communication parameters and default values. This method performs the same function as a manual power-on reset.

It adjusts the darkness relative to the current darkness setting.

It sets the type of media used (continuous or non-continuous) for purposes of tracking.

It selects the type of media being used (Thermal Transfer or Direct Thermal) in the printer.

It reloads the printer's factory configuration.

It determines the action the printer takes after a label or group of labels has printed.

It causes a printer in Pause Mode to resume printing.

Gets or sets information about the thermal printer used for printing.